Are there any "easily accessible" solder pads on the plug PCB to reprogram the ESP32-C3 module on these units.
If not, is there a way to non-destructively remove the bottom plastic plate so I can access the contacts of the module from underneath the PCB?
Thanks.
Thanks for the blog loaded with so many information. Stopping by your blog helped me to get what I was looking for. ViMusic team
When you use a genuine service, you will be able to provide instructions, share materials and choose the formatting style. visit GeometryDashMod.net
This is a truly good site post. Not too many people would actually, the way you just did. I am really impressed that there is so much information about this subject that have been uncovered and you’ve done your best, with so much class. If wanted to know more about green smoke reviews, than by all means come in and check our stuff. Visit tiktok18plusapp.net
Need to connect GP9 to GND to enter flash mode
https://tasmota.github.io/docs/Pinouts/#jw-2s-esp32c3